[Ushiba, Washimi]
Today's work at MCE:
- Visual inspection for the EQ stoppers, Coil & Magnets -> look fine, all magnets look to be almost centered in each coil bobbin
- Released the gluing jig for a magnet -> OK
- Released the HR/AR surface EQ stoppers -> no one was touched, but the magnets moved in a yaw direction in each coil bobbin
- Checked & center the oplev
- Brought closer the old-lower side-stoppers
- Brought closer the new-upper side-stoppers
- Brought closer the HR/AR surface EQ stoppers
- Checked the oplev -> gone out of the QPD
- Checked the EQ stoppers -> The HR/AR surface stoppers might be touched on the mirror -> Brought farther the HR/AR surface EQ stoppers
- Checked the oplev ->OK
- Suspension health check -> OK
- IMC alignment (klog28912)
Atouched files are final status photos
