Reports 1-1 of 1 Clear search Modify search
IOO (General)
kohei.yamamoto - 19:35 Tuesday 12 March 2019 (8380) Print this report
Connect Moku:Lab in PSL room to network

Kokeyama, Kohei Yamamoto

We connected the Moku:Lab in the PSL room, Moku-000393, to the network. 
Therefore, as long as cables of the signals to be measured are hooked up to the Moku:Lab, we can do measurements with the Moku:Lab even in Mozumi. 
Moreover, when you control the Moku:Lab with an iPad, you don't have to bother to swich connected Wi-Fi. This might be convenient in many cases, e.g. when you want to share datas you measure with the Moku:Lab to the dropbox. 
I think it is good to implement for convenience and stress-free works. 

==How we did ==
1. connect the Moku:Lab to the network with the swich, as shown in the pictuer below
2. assign the IP address, 10.68.10.253, to the Moku:Lab by the app of Moku:Lab
3. install the pymoku following https://www.liquidinstruments.com/python/

==Result==
We could successfully control the Moku:Lab with k1ctr12.

Images attached to this report
Comments to this report:
keiko.kokeyama - 10:05 Wednesday 13 March 2019 (8390) Print this report

Oh. I just realized that actually we didn't need the network switch. I think Moku:lab can be connected from any CDS network as long as the fixed IP address is given to it at the setting screen of the Moku:lab app. There is the setting icon at the beginning of the app.

As Yamakoh noted in the main post, this is super convenient and we recommend for everyone to try!

Search Help
×

Warning

×