VIS (PR2)koji.nakagaki - 19:21 Tuesday 26 October 2021 (18698)
Print this reportSurvey of POS and POP for consideration of installing a rebooter[Yokozawa, Nakagaki]
In order to make a decision on the installation of the rebooter, we surveyed the POP and POS picos.
POS optical table There is one set of pico motor (mirror mount) on the optical table: Photo 1 There is one pico driver on the side of the optical table: Photo 2 Pico motor and Pico driver are not connected to each other.
POP optical table There are three sets of pico motor (mirror mount) on the optical table: Photo 3,4 There is one pico driver on the optical table: Photo 5 Pico motor (3 sets) and Pico driver are not connected.
POP-POM There is a Dsub-IF for Pico in the feedthrough on the first floor of PR2: Photo 6 One Pico driver is placed in a small plastic rack next to the PR2: Photo 7 Pico motor and Pico driver are connected to each other.
[Confirmation] 1.For both POS and POP, the pico motors on the optical table were not connected, but do they need to be in operation during the observation? 2. Is a rebooter necessary for the pico motor drivers on the POS and POP optical tables? 3. The pico motor on the POP-POM is running, so I'm thinking of installing a rebooter, is that correct?
Images attached to this report
Comments to this report:
takaaki.yokozawa - 7:59 Wednesday 27 October 2021 (18702)
Print this reportPOS-POM
We found the driver is placed in the SR2 mini rack on the 2nd floor of the clean booth, and there are cable between mini rack and SR2 feedthrough(1st floor). From our eye, there are already set the rebooter, but we will ask Ikeda-san about installation.