Reports 1-1 of 1 Clear search Modify search
VIS (IX)
ryutaro.takahashi - 21:20 Thursday 28 January 2021 (15860) Print this report
Cabling for cryo-payload

[Takahashi, Sato, Horiuchi + CRY (Tomaru, Ushiba)]

We connected the cables for cryo-payload to the BF.

  • Two 5-mm spacers and two 7.5-mm pipes were used for the janction box to connect the maraging wires. 
  • New small hexagon was used to fix the cables on the wire.
  • The cables were connected to the upper connector cables and fixed to the side plates on the BF cup.
Images attached to this report
Comments to this report:
takafumi.ushiba - 8:59 Friday 29 January 2021 (15864) Print this report

Additional information for procedure.

First we make three groups of cables (category A, B, and C) and tied each category by peek ties.
Then, Each-category cables are tied to maraging rod.

In this time, we connected the maraging rod before installation different from the previos installation.
Then, we confirmed that maraging rod can be installed after the connection

ryutaro.takahashi - 21:19 Friday 29 January 2021 (15866) Print this report

[Takahashi, Sato, Horiuchi]

We finished the cabling around the BF. The cables were fixed to the small hexagon and the bottom of BF.

Images attached to this comment
Search Help
×

Warning

×