The target temperatures for each area and positions  are those during O3GK in basic.

However, EXV area temp (~24.5C) during O3GK seemed to be high because of FFUs operations, At present it is ~ 21.6C because of a cooler that is operated at low wind cooling mode.

So we need to find optimum temperature for EXV.  

The target temperatures for each area and positions  are those during O3GK in basic.

So,

15637 and 15816

However, EXV area temp (~24.5C) during O3GK seemed to be high because of FFUs operations in addition to its originally higher temp than other area.

At present it is ~ 21.6C because of a cooler that is operated at low wind cooling mode.

So we need to find optimum temperature for EXV.  

If we found some difficulties about temperature balance all over the center area, we should reconsider the target temperatures.

I turned on  a Delongi heater near SR3 (level 4) and a dehumidifier in front of SR-C cooler. around 13:30.

I will monitor the temp around SR3.

I placed two mini heaters on the 2nd floor between SR3 and SRM

SR3 temperature is 22.7C around 16:00 and it increased rapidly with these "loca"l heaters near SR3 and SRM.

So I decreased the heating level for 4 (1.5kW)  to 1 (~600W) of the delongi heater near BS-C cooler no to let them be too high within several hours.

I leveled up from 1 to 5 again for the delongi heater to speed up the temperature enhancement for SR3.

I added a 500W heater beside the lid of SR2 (+ x side) on the 2F in the BS area.

In addition to this, two delongi heaters around BS  were turned on and I set level 3 ( ~ 900W) heating power around 10:00.