[Hayakawa, Sawada, M. Takahashi, Tamori, Izumi, Michimura]
Past activities: klog #2625, #6681, #6807
We have placed the POS table to the nominal position (photo).
The locations of the anchor holes dramatically matched with the footprint of the table and we could successfuly clamp the four legs with yellow clamps (photo).
Note:
- For clamping optical tables, use yellow clamps (blue ones are for pylons; IMC REFL table and IFO REFL table use blue ones, but they are actually incorrect).
- We have moved and restored the changing area to BS cleanbooth in order to put the POS table into the cleanbooth (photo).
- Before moving the table, we have replaced the K400 flange for POS beam.
This POS optical table intallation was the last full optical table installation. Thank you!
(Remaining tables are POX, POY, and IMMT2T, which are simple ones)
Actually the height is just the right height. I was also surprized because when we did IMC REFL and IFO REFL tables, I think we were told to use bule ones. Blue ones are a bit higher than yellow ones. The screws on the pushing points are not tightened; they are used to place the pusing point to the right position.