Hirose-san, Ikeda

> We placed the BS after the shutter and tried to turn the HWP remotely, but we couldn't. Specifically, we turned it at ‘K1:SYS-HWP_IFO_REFL_WFS_STEP_TOTAL_DEG’. The number on the MEDM screen"K1SYS-HWP_CALIB.abl" changed, but the IFO REFL WFS HWP on REFL table did not turn. I couldn't resolve it within today's work, HWP remains as is. The power before and after BS is as follows. (PDFfile)

そのままで問題なく動作していた。

手順:
1. k1hwp4(IFO_REFL_WFS)の制御PCとの接続を確認
 Ping: OK, ssh: OK,　lsusb: OK

2. コネクターの接続
 => 問題なし
 
３. HWPを見ながら10deg動かしてみた。
 動作は正常、ただし指定した10degは回転しなかった。
 => キャリブレーションは必要と考えられる。

結果:
HWPは正常に動作することが確認できた。
---
Hirose-san, Ikeda

> We placed the BS after the shutter and tried to turn the HWP remotely, but we couldn't. Specifically, we turned it at ‘K1:SYS-HWP_IFO_REFL_WFS_STEP_TOTAL_DEG’. The number on the MEDM screen"K1SYS-HWP_CALIB.abl" changed, but the IFO REFL WFS HWP on REFL table did not turn. I couldn't resolve it within today's work, HWP remains as is. The power before and after BS is as follows. (PDFfile)

It worked fine as it was.

Procedure:.
1. check the connection of k1hwp4 (IFO_REFL_WFS) with the control PC
 Ping: OK, ssh: OK, lsusb: OK

2. connectors.
 => no problem
 
3. ran 10deg while watching HWP.
 Operation normal, but did not rotate the specified 10 deg.
 => Calibration is considered necessary.