[Ikeda, Yasui-san] ETMYの電力調整器のインストールとリボンヒーターの接続を行い試験を行いました。 SLOPEを4、目標温度を40°Cに設定して試験を開始しました。 約4時間後に34.1°Cまで上昇することを確認しました。 正常に動作していることが確認できました。 目標温度を0°Cに変更して作業を終了しました。 [温度調整機器の残作業] IY: 電力調整機の設置、温度上昇試験 => 電力調整器が修理中です。 IX、EX、EY、PRM、PR2、PR3、BS、SRM、SR2、SR3: 使用可能 [主な作業内容] 電力調整機の設置:電力調整機の入手待ち 温度上昇試験:電力調整機のSLOPの値を決めて30℃程度まで上がるように設定する。 --- [Ikeda, Yasui-san] We installed the ETMY power controller and connected the ribbon heater for testing. We started the test with SLOPE set to 4 and target temperature set to 40°C. We confirmed that the temperature rise to 34.1°C after about 4 hours. It was confirmed that the system was operating normally. We changed the target temperature to 0°C and finished the work. [Remaining work on temperature controller] IY: Installation of power controller temperature rise test => Power regulator is under repair. IX, EX, EY, PRM, PR2, PR3, BS, SRM, SR2, SR3: Available [Main work]. Installation of power regulator: Waiting for power controller to be obtained. Temperature rise test: Determine the SLOP value of the power controller and set it to rise to about 30°C.