[Ikeda] 午前中、ITMXのリボンヒーターを24時間使用できるようにしました。 電力調整機のSLOPを2に設定して目標温度40℃に設定して実際のヒーターが何度で定常状態となるか確認しました。 5時間運転したところ約30.2℃で定常状態となりました。 目標温度は0℃に変更して作業を終了しました。 [Ikeda, Takahashi-san, Yasui-san] 午後、我々はBSとSR2のリボンヒーターをコルゲート菅に巻きました。 保温と熱電対のインストールは明日以降行います。 --- [Ikeda] In the morning, I got the ITMX ribbon heater ready for 24-hour use. I set the SLOP of the power regulator to 2 and set the target temperature to 40°C to see at what temperature the actual heater would reach steady state. After 5 hours of operation, the heater reached steady state at about 30.2℃. The target temperature was changed to 0°C and the work was finished. [Ikeda, Takahashi-san, Yasui-san] In the afternoon, we wrapped the BS and SR2 ribbon heaters around the corrugated tube. Thermal insulation and thermocouple installation will be done tomorrow.