2021.1.19 Sato, Horiuchi 〇 F3の準備とチェック  ・F3をクリーンブース内に移動した  ・F3のカップを開けた  (カップの嵌め合いが非常にきついため、金属ヘラ、プラハンマー、アルコールを使って開けた)  ・FR ブレードを強化されたもの(JGW-D1706457-2)に取り換えた。  ・FRモーターの動作チェック   <チェック内容>    1. モーターの回転方向     モーターの回転方向が逆になっていた。     そのため以下のようにモーター配線を変更し、     右回転命令を与えると、FRがキーストーンを引き上げるようにした。    [ pin No.] [Before] [After] 1 GRN BLK 6 GLY WHI 2 BLK GRN 7 WHI GLY    2.上下可動範囲     現在のFR高さ(設定値):41mm     上側限界高さ     :62mm     下側限界高さ     :20mm     ・GAS LVDTの抵抗値チェック    [ pin No.] [resistance (ohm)] 1-6 Primary 190 2-7 Secondary 75.6 3-8 Actuator 109.6 〇 BF伝達関数測定の準備  ・測定の準備のため、BFキーストーンを固定した。   伝達関数の測定は三代さんによって行われる。 以上 ========================== Preparation and check of F3 2021.1.19 Sato, Horiuchi * Moved the F3 into the clean booth. * Opened the cup of F3. (The fit of the cup was very tight, so we used a metal spatula, plastic hammer, and alcohol to open it. * Replaced the FR blade with a reinforced one (JGW-D1706457-2). * Checked the operation of the FR motor. Contents of check 1.Motor rotation direction The direction of rotation of the motor was reversed. Therefore, the motor wiring was changed as shown below. With this change, the FR now pulls up the keystone when the right rotation command is given. [pin No.] [Before] [After] 1 GRN BLK 6 GLY WHI 2 BLK GRN 7 WHI GLY 2. Vertical movement range Current FR height(set value): 41mm Upper limit height: 62mm Lower limit height: 20mm * Check the resistance of GAS LVDT. [pin No.] [coil name] [resistance (ohm)] 1-6 Primary 190 2-7 Secondary 75.6 3-8 Actuator 109.6 * Preparation for BF transfer function measurement In order to prepare for the measurement, the BF keystone was fixed. The measurement of the transfer function will be done by Miyo-san. Translated with www.DeepL.com/Translator (free version)