[K. Nagano, Akutsu, Aritomi, Kita, K. Tanaka]
(Report on yesterday work)
Before polarity check (klog6389), we connected Dsub cables of coil actuators.
(We could prepare DAC port thanks to Pcal team.)
In the end, the cabling configuration was as follows,
ADC1
| Port Number | #1 | #2 | #3 | #4 | #5 | #6 | #7 | #8 |
| Channel | LVDT V | LVDT H | Geophone V | Geophone H | IR QPD1 | IR QPD2 | GR QPD1 | GR QPD2 |
ADC0
| Port Number | #5 | #6 | #7 | #8 |
| Channel | Misc 1 | Misc 2 | OpLev QPD | IR/GR PD |
DAC0
| Port Number | #3 | #4 |
| Channel | HP Coil Driver for LVDT H | HP Coil Driver for LVDT V |
Note1: V and H means vertical and horizontal, respectively.
Note2: Misc 1 and 2 in ADC0 are just spares and are not connected to anything in RT model for now.
Then, we labeled all TMS related cables which had been installed at this moment.