Cabling for BIO system, stepping motors are ongoing;
  - Setting For stepping motor drivers is done in accordance with wiki's procedure.
    - IP number for K1:STEPPER_ITMX_GAS is set to 10.68.150.43, while IP for K1:STEPPER_ITMX_IP is 10.68.150.44
    - Since I could not get a long LAN cable inside thr tunnnel today, the LAN for the stepping motorr drivers are not connected to a hub; they are not on the network. Soon this will be cnnected.
  - After connection work, BIO for GAS, BFV and BFH look working properly though, BO for PI deos not look responded properly. Further investigation would be necessary.