1) Started the preparation of EQ stop for the F3.
2) Assembled the side stoppers for F3.
3) Assembled the end plate for F3. Attached the side stoppers, the release sensors, and the support screws.
4) Made the short cables for the BF damper.
5) Set an LVDT driver and connected the LVDT for BF,
6) Calibrated the LVDT for BF. The height of the secondary coil was shifted by 1mm.
7) Modified the FR for BF. The fixing point of the blade top was changed.
8) Checked the range of FR for the BF again.
9) Extended the EQ stop to the F3 stage. Attached the support plate for the BF damper.
10) Set the foot holds.
