Simon, Hasegawa, Miyo, Akutsu:

Attached back the oplev reflectors to the WAB, and set up an oplev, while a viewport window was replaced with the actual oplev window (in the -Y+X direction). Along with those, two heater plates (Fig 3) and four thermometers were attached (Fig 2). Each thermometer has a serial number (Fig 1). In addition, we connected the other cables to the distributor (Fig 4).

Then detached the protectors again and saw the oplev's reflected beam (Fig 5 and 6). The digital system was not still setup so we did not connect the QPD; we just put a ruler and checked the movement of the reflected oplev beam by our eyeballs.)

After we attached the protectors again, Simon and I tried to attach a heat link to the WAB (Fig 7, 8, and 9), but found need to consult with some guys. For reference, we did like this in Mitaka.

Details here.