[Takahashi, Sato, Shindo, Sawada, Okutomi]

Cabling around the BF

• Done:
  • Stepper motor for the Fishing Rod (operation checked)
  • Release Sensors on the EQ-stop DP stage
• Ongoing:
  • GAS LVDT and actuator
  • Release Sensors on the EQ-stop BF stage
• Setup for GAS LVDT operation check and rough calibration got ready
  • We can get single-ended signals using a D-sub => BNC Converter (JGW-S1605714)
  • We're going to check the LVDT signal with an oscilloscope (it means analog setup)

One feedthrough flange installed

• Shindo-san and Sawada-san installed a feedthrough flange on the north side of the top chamber

Photos >>> https://goo.gl/photos/JZR85StDGddZoXWQ7